Modbus Motion Interface

Read_Word(System_+_InputBit1_w); {read input 1}
Read_Word(System_+_InputBit2_w); {read input 2}
Read_Word(System_+_InputBit3_w); {read input 3}
Read_Word(System_+_InputBit4_w); {read input 4}
Read_Word(System_+_InputBit5_w); {read input 5}
Read_Word(System_+_InputBit6_w); {read input 6}
Read_Word(System_+_InputBit7_w); {read input 7}
Read_Word(System_+_InputBit8_w); {read input 8}

Description

The Input Bit registers returns the state of the input bits referenced by the parameter. A non-zero value represents a high voltage and a 0 represents a low voltage. Note that this performs a direct read of the input bit and does not include setup configured properties that apply to a named resource that might be referencing the input bit such as bit inversion.

Escapes

A Parameter Out Of Range Escape Code will be generated if the parameter references an input beyond the range of the controller.

Examples

Query input 5 setting.

if Read_Word(System_+_InputBit5) <> 0 then
 Show_Message('Input 5 is high')

Related Topics

Set Output Bit