I/O Block

Description

I/O points on MMC can operate as both inputs and outputs. The "Input Bit" expression will report the level of the point whether in is being driven internally by an output driver or driven externally by a sensor. However it is necessary to indicate if the driver should be active as an output. This command turns on the driver so that the output voltage can be controlled

Escapes

The Configure IO As block does not produce any escapes.

Examples

This block list shows a prompter message if an input is true:

This block list starts blinking when a switch is pushed and continues until the switch is released. Note that the condition of "on" or "off" can be selected:

Related Topics