Description

After developing an application it is necessary to commission or deploy the application for use.

Standalone Operation

The application can be stored in the controller to run when the controller is powered. To store a project in the controller run the project, press the red stop to stop the project, and then select from the menu "File | Save In Controller":

If the project is not run first this message is shown:

Snap2Motion will show file save progress...

...and conclude with this message:

When the controller is powered any Autostart tasks will be performed and then the Main.Setup procedure will be performed (if it has been described). To stop application behavior when the controller is powered on save a blank project into the controller.