Set Output Bit
Modbus Motion Interface
Write_Word(OutputBit_+ 1,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 2,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 3,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 4,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 5,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 6,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 7,<1 for high, 0 for low>);
Write_Word(OutputBit_+ 8,<1 for high, 0 for low>);
Description
The Set Output Bit registers controls their respective electrical outputs. A non-zero value applies "Logic Pwr" voltage to the output pin. Writing a 0 values disconnects the output pin leaving it open.
Escapes
An error will occur you the register is read as the OEM2T does not support readback. If the value added to OutputBit_ creates a sum outside the available output range an "event not defined" (3001) will be reported.
Examples
Turn output 2 on.
Write_Word(OutputBit_ + 2,1);
Turn output 1 off
Write_Word(OuputBit_+1,0);
Related Topics